Tuesday, October 1, 2024

Saturday, September 28, 2024 -- laying out frame and joining with biscuits

The cross pieces need to be shortened about two inches, so that the dry erase board would have a good place to be mounted.
If I make the board flush with the frame, the mounting holes are too close to the edge.
I'm going to use the smallest biscuits so the blade on the biscuit joiner needs to be changed.
Remove the base plate.
This locknut was too tight.
Had to use a hammer on the end of the wrench to break it loose.
After installing the small blade, this arm has to be relocated to change the stroke of the tool.

 

No comments:

Post a Comment