Dining table bench - part 8 -- removing the material from the board for the butterfly

Will use the router to take out most of the butterfly joint area of the board.

Will use a 1/4" straight cutter.

It's interesting that this set is made in Italy...

Set the depth of cut to be just a little bit shallower than the height of the butterfly.

Done with the router.

Cutting into or over the line would be a disaster!

Was able to not get too close to the line.

The rest of the wood removal will be done with chisels.

 

Tuesday, December 29, 2020 -- Manhattan Beach Pier -- Day after the rain

Watermelon flavor Kombucha...  Not bad...

Very windy day.

Head-wind all the way back home!

The people on the right are the ones giving out the "sample" tea...

Super clear day (day after rain).

Catalina...

 

Thursday, December 31, 2020 -- Butterfly Trail, Simi Valley -- Part 2

 

Fit Lease & BBQ Steak...