 |
| I need something like this cable guide that goes on the bottom of the bottom bracket for the Teledyne Titan... |
 |
| Rear wheel rim |
 |
| Front wheel rim |
 |
| Pedals... |
 |
| Dura Ace groupset on the bike. Crank Arms... |
 |
| Even the crank arm bolt caps are Dura Ace. Nice! |
 |
| I'm not familiar with this "JB" logo... |
 |
| Shimano bottom bracket bearing |
 |
| Dura Ace wheel skewers... (note that the rear drop outs are Campagnolo...) |
 |
| Dura Ace rear brake, including the brake pads! |
 |
| Dura Ace rear wheel hub |
 |
| The bottom aluminum one is what came on the bike. I had a spare used carbon fiber seat post. If it fits, I'll put this on the Trek... |
 |
| This is the seat post clamp that came on the bike. Took it apart and cleaned the parts (forgot to take a picture before cleaning...). |
 |
| There's a portion of the clamp where the aluminum is damaged and has a large raised burr (hard to see but it's just below the 3.18 stamping...). |
 |
| Used a file to clean up the burr. Now it's nice an smooth. |
 |
| Ready to go back on the bike. |
 |
| The interface where the seat post clamp goes is somewhat scratched up and dirty. |
 |
| After cleaning (with a scotchbrite pad). |
 |
| Had to spread the gap open (with a large screwdriver) so that the seat post will install easily. |
 |
| First reinstalled the seatpost clamp. |
 |
| Installed the seat post & tightened the clamp. |
 |
| The carbon seatpost is made by Specialized. |
 |
| Just bought this seat the Long Beach Motorcycle Swap Meet a couple of days ago. Installed it on the bike (leveled it also). It looks good. |
