 |
| Didn't know about this event. Looks like it could be fun to attend... |
 |
| Someone was asking almost $19,000 for this pretty poor condition 914 (rust holes in the quarter panels). This to me is a $5,000 car, at most... |
Friday, March 29, 2019
Willow Springs, Sunrise & Long Beach Swap Meet -- Sunday, March 10, 2019
Fixed the Gate to the back yard
 |
| Added a reinforcement behind the bottom of the gate. Two of the slats had broken off and one was about to fall off... (didn't take a picture before the repair...) |
 |
| Used a piece of pressure treated wood. Drilled vertical holes through the lower stile & used lag-bolts to hold it all together. Should last a few more years. The gate wood is getting pretty rotten so at some point will have to build new gates... |
(3) Schwinn Approved Road Bike Wheel Hub - Made in France - Clean balls & final reassembly
 |
| Need to clean the old grease off the ball bearings |
 |
| All parts are clean and ready for assembly |
 |
| Grease first applied to the bearing race |
 |
| Now the balls will stay in place when located on the race (on both ends) |
 |
| Install the shaft & the outer bearing race (the part with the flats on it) |
 |
| Then a washer (with a notch so that it doesn't rotate) |
 |
| Then the nut to lock the outer bearing race in place to keep the right amount of play around the bearings. |
 |
| Done (nuts on the outside are for installation on the bike |
Subscribe to:
Posts (Atom)