After removing the clamps (glue dried overnight). The outer side of the front lid.
The inner side of the lid.
The lid is pretty flat after gluing.
The glue joint is where the tear line is for the leatherette. The two pieces are pretty straight.
This is the LH side slide pin.
The LH side slide pin is slightly bent. It's probably from the force when the lid is slid out and the pins hit the end of the channel in the case side that they slide in. The pins are not loose.
This is the RH side of the lid. Again showing that the two pieces glued together are pretty straight.
The leatherette is lifting at this corner.
Another set of pictures of the RH pin.
No comments:
Post a Comment