 |
| I want to reduce the footprint of this cart. Will remove the tool holder on the LH side and modify the handle. Looks like the tool holder is held in place with just the two Phillips head screws in the middle of this picture. |
 |
| The tool holder hangs out quite a bit. |
 |
| It was very easy to take off. The screws were not too tight. |
 |
| Put the screws back so that it doesn't have empty holes... |
 |
| Next, I will cut off the tubing that extends out from the footprint. Will figure out something to cover the cutoff tube ends... |
No comments:
Post a Comment