 |
| The front brake pad to wheel rim gap is as small as I can make it without it rubbing when not applied. The wheel is slightly out of true so there's a slight wobble when the wheel is turning. This requires that there be a slightly larger gap from the pad to the braking surface on the rim. The smaller the gap can be, the more responsive the brakes will feel and perform... |
 |
| The rear brake pad to wheel gap. There's slightly less wobble on the rear wheel so the gap can be a little smaller than on the front... |
 |
| Cinelli bar tape, as installed. I chose to leave a section of the handlebar near the gooseneck exposed. |
 |
| The bar tape was just long enough (not much extra length...). |
 |
| The fit of the brake lever hood to the bar is very good (no gaps). |
 |
| The front end of the bike is basically done. Next is the drivetrain... |
No comments:
Post a Comment