The same as the last one.
Silver bu with a Mavic Kysrium label on it.
Cleaned the end with the nipple.
And the hub end.
Applied grease on the nipple and the shaft (hopefully to prevent future corrosion).
A little bit of grease on the fixed end too.
Started threading the nipple in the rim.
The hub end of the spoke.
Now there's two silver spokes.
Tightened the nipple to get some good tension on the spoke.
Will put the wheel on the bike and check for runout.
If it's true enough, will use the wheel.
It's kinda on it's last leg.
If there's any future issues, I'll have to replace the wheel.
