Friday, September 10, 2021
Ford Swap Meet -- Buena Park Elks Lodge -- Saturday, August 28, 2021 -- Part 8 -- Kodak lens storage & motorcycle carb intake tube/screen
Amal, air tube (intake) 900 series concentric
Air tube (bell mouth) for AMAL 900 series concentric carburettor, UK. Approx 44mm ID on thread approx 60mm long, with gauze in outer end. Overall length 2-1/8 inch
Goes on these motorcycle carbs...
Long Beach Motorcycle Swap -- Sunday, August 29, 2021 -- Part 4 -- Park Tool (bicycle tools) bottom bracket tools (BBT-19.2, BBT-22, BBT-18) & a freewheel tool (FR-6)
BOTTOM BRACKET TOOL – 16-NOTCH 44MM OD
"The BBT-19.2 is used to remove and install external bearing crankset bottom brackets. Fits external bearing bottom brackets with 16 external notches and an outside diameter of approximately 44mm.
- Fits:
- Shimano® BB80, BB5700, XT® BB70, BB51, and previous external bearing threaded cups
- External threaded types for Campagnolo®, Chris King®, FSA® MegaExo®, SRAM®/Truvativ® GXP®, Race Face® X-type, Surly®, Wheels®, Fulcrum®, Hope™ (non-BSA30) and others
- 16-notch Bafang® BBSH, BBS02 Mid Drive motor lockrings"
BOTTOM BRACKET TOOL – 20-SPLINE
The BBT-22 is a shop quality tool for installing and removing Shimano® and ISIS Drive™ splined 20-tooth bottom bracket cups. Made from investment cast steel, the BBT-22 utilizes a flat tooth profile to ensure maximum engagement with the bottom bracket cup. Can be used with a 3/8" drive torque wrench, 3/8" ratchet driver, 32mm wrench, FRW-1 Freewheel Remover Wrench, or 1" wrench.
The 20-tooth pattern is used on a wide variety of bottom brackets, including models from Shimano®, Truvativ®, Race Face®, FSA®, and others. The tool clears the oversized spindles of ISIS Drive™ and Octalink®.
BOTTOM BRACKET TOOL – 8-NOTCH
"The BBT-18 is a heavy duty, investment cast tool for installing and removing the following:
- Shimano® Octalink® right side bottom bracket cup with external notches
- Bontrager® ISIS Drive™ bottom bracket cups
- Front chainring lockring for Bosch® Gen 3 and Gen 4 e-bike systems and Specialized® Levo® Brose® e-bike systems
- 8 notches with an outside diameter of nominally 43.4mm
- The inside-to-inside width is approximately 38mm
- Each notch is approximately 3.9mm wide
- The hole in the center of the casting is 22.5mm, and will not fit over 30mm spindles
- Can be used with a 36mm crow foot (such as the TWB-36) or open-ended wrench:"
FREEWHEEL REMOVER – BMX & SINGLE-SPEED
Heat treated alloy tool steel, one inch base fits wrench or bench vise. Thin wall construction allows use without removal of cones and locknuts.
Removes four-notch BMX / single-speed freewheel from hubs with 1.37 x 24 TPI threads
The FR-6 has four notches approximately 32mm across measured inside to inside and 40mm outside to outside
Fits over axles up to 16mm thread diameter
Always use a skewer or axle nut to hold tool firmly in place during removal
Subscribe to:
Posts (Atom)