Pretty surprising failure...
Bought an exact replacement part at the local hardware store.
Fixed...
Monday, January 4, 2021
Dining table bench - part 3 -- Top surface planed and sanded...
The top surface has been planed and sanded.
There's this crack on one end of the board.
Will try to out a butterfly joint near the end.
The backside of the crack.
After the butterfly, may fill the area with an epoxy...
Adjusting the rear brake pads...
The right rear brake pad is way out of alignment...
After adjusting...
The left rear brake pad is a little bit high but not too bad.
After adjusting...
Also adjusted the brake cable to minimize the air gap for a more responsive brake lever.
Subscribe to:
Posts (Atom)