 |
| The cross pieces need to be shortened about two inches, so that the dry erase board would have a good place to be mounted. |
 |
| If I make the board flush with the frame, the mounting holes are too close to the edge. |
 |
| I'm going to use the smallest biscuits so the blade on the biscuit joiner needs to be changed. |
 |
| Remove the base plate. |
 |
| This locknut was too tight. Had to use a hammer on the end of the wrench to break it loose. |
 |
| After installing the small blade, this arm has to be relocated to change the stroke of the tool. |
No comments:
Post a Comment