Before vacuuming. The felt is is pretty rough shape, especially in the RH front side...
Close up view before vacuuming
After vacuuming
Something pretty heavy & rough must have been stored in this spot...
Before cleaning the drawer front...
Closer view of the RH knob/pull before cleaning
LH side of the drawer before cleaning
Closer view of the LH side knob before cleaning
After cleaning and the drawer put back in the case; RH side of the drawer
LH side of the drawer after cleaning
LH side of the drawer
RH side of the drawer
Drawer after cleaning, showing the bottom
The knobs screw out
The escutcheon is a thin stamped piece of sheet steel
The edge of the escutcheon leaves an impression in the wood
The knob appears to be made of three pieces: The screw, a shaft center section & the cap piece on top.
For now, I've decided to not remove all the knobs.
I could remove them and clean them individually, especially if I wanted to get them to be very shiny.
But, since I'm going for a cleaned but used look, just cleaning with them in place results in a more used & worn look.
No comments:
Post a Comment