 |
| I had taken the drawers out (required bending some metal tabs at both side of each drawer). The bottom of the box was pretty bent up (about 1/2" in the middle!). Used some hammer and dolly work to bend it back pretty close to straight. Also took a bend/dent out of the top opening of the box to make the lid close better (nearly perfect after). Then, everything was cleaned. Turned out pretty good. |
 |
| There were a couple of sharp dents in the back of the box (can kind of see the the white area). Hammered these dents out also. |
 |
| Started filling up the box with tools and other junk. The pictures that follow below show the progression of adding more & more stuff... |
No comments:
Post a Comment