 |
| The lock tab is bent -- used a hammer to bend it back straight |
 |
| There's a couple of dents/spits in the back. Will take out the drawers so that I can hammer the surface back close to flush. |
 |
| Blue-Point sells a very similar tool box currently; KRW83C & it sells for $146. I think the C stands for made in China... |
 |
| The bottom is bent. Will try to straighten. |
 |
| There's a metal tab on the side of the drawers that need to be bent in order to get the drawers out. |
 |
| Using a punch & hammer, bend the red metal tab in... |
 |
| I bent this one pretty good (a little too much) |
 |
| This side was bent just enough to get the drawer out. |
 |
| All the drawers are out so now the back and the bottom can be bent back into shape. |
 |
| This picture clearly shows how much the bottom is bent... |
 |
| The back is damaged behind the center drawer locking mechanism. It will be a little bit tricky to bend back... |
 |
| Ran out of time. Put all the stuff in the corner for now... |
No comments:
Post a Comment