Thursday, October 22, 2020

Phil & Enzo - part 23







Old & Rough Tool Case - part 15 -- Vacuuming & Cleaning the Drawer Fronts -- Second to the Top Right Drawer

Before vacuuming...


After vacuuming...


Before cleaning


Before cleaning


Before cleaning


Before cleaning

Showing the full bottom of the drawer...


This one marked "28-2"


Guessing that the "2" goes above the "3".
I swapped the top two RH drawers.


In the cleaning process.
Got tired of using the kitchen scrubbing sponge for the knobs.
I used the scrubber on the wood but swapped to using a blade to scrape off the dirt/rust on the top of the knobs.  It works well but you have to careful not to cut into the metal.
This picture shows the knob top cleaning, mid-process...


After cleaning...


After cleaning


Drawer being put back in the case...


Now the three half width drawers are done cleaning.


Also cleaned the vertical drawer guide holding piece between the half drawers so that the level of clean matches the drawers.
What's neat is that they but the "bead" feature on this piece also, so that the feature runs through the LH & RH half drawers.
Nice detail touch...
The screw at the top of this picture is the front lid stop so that it's positioned correctly to align with the catch portion of the latch and to ensure that the front lid ends up being flush with the case when it's in the closed position.
Since it's a screw, it's easily adjustable.


Close-up of the RH knobs, showing the before and after, as compared to the full width drawers below that have not been cleaned yet...


LH knob contrast...

 

1995 Lexus Coupe Brochure (very high quality, spiral bound, large format, thick paper, very glossy pictures & many fold out pages)




These cutaway drawings look like they were done by David Kimble.
But, they're not signed...


 

Thursday, October 15, 2020 -- Manhattan Beach Pier (fog rolling in, mid-day...)

The fog was rolling in, quickly...
It's another warm day (high of 88F at home).

Wednesday, October 21, 2020

Old & Rough Tool Case - part 14 -- Vacuuming & Cleaning the Drawer Fronts -- Top Right Drawer

Started on the top right drawer...


1/2 width shallow drawer...


This is during the vacuuming process.  There's a patch on the right that's not been done yet...


After vacuuming...


One good thing about the sheet metal bottoms is that they're very thin so it actually significantly increases the drawer height/volume.


The knob's front is covered in black/brown dirt/rust.


Before cleaning...



The piece on the left is the drawer front with the bead feature at the bottom.  The front piece is made to overhang the bottom of the drawer on purpose.  During the manufacturing process, the bottom of the drawer front is sanded to create an even gap at the bottom to the next drawer down.  This process is repeated with each drawer so that in the end, all the drawer gaps are even and nearly perfect.


Showing the drawer side piece with the guide channel...


The drawer back panel.


As best I can tell, this one says "28-3" on it...


After cleaning.


After cleaning, close-up.


Top right drawer put back in.


I'm guessing that the "28-3" may indicate that this drawer is the second from the top drawer.  The other shallow drawer says "28-2" on the back.  I'm guessing that the 2 goes above the 3...

 

Wednesday, October 14, 2020 -- Bike ride & waiting tool case in the garage...

Went for the usual lunch time bike ride to Manhattan Pier.
It was pretty warm today but not too bad.  It's usually about 5 to 10 degrees cooler at the beach.


The tool case is waiting patiently for me to reinstall the front lid...