 |
| The Lancia Dash doesn't fit so I need to move this tool box and base over to the left, as much as possible. |
 |
| The Kennedy box, just to the left of the one that needs to be moved, was an ex-Douglas box. It has this sticker on the side of it (Douglas merged with McDonnell in 1967 to form McDonnell Douglas, so this box is most likely pre-1967.). |
 |
| Although it's not centered on the red Snap-on box, it's still stable and more importantly, the load applied to the flat file, through the Snap-on box, is still focused on the rear edge & right corner of the flat file, which is the strongest part of the flat file. |
 |
| Moved the Lancia dash back as far as it can go on the taller flat file (between the tool boxes). |
 |
| It's a tight fit but it's in there. Later, at some point, I'll probably move the tool box on the right of the dash an inch or two over so that the dash isn't so "jammed" in. But for now, it's OK. |
 |
| Need to find homes for some of the stuff on the beige flat file... |
No comments:
Post a Comment