Thursday, January 2, 2020
Friday, December 20, 2019
Bunch of Tools -- chemical cleaning of dirt/grease in the sink
 |
| Cleaned these tools with some chemical cleaner & rinsed them with water. They're drip drying in this picture. |
 |
| After drying with a paper towel. |
 |
| These were also dried using shop-air to get water out of any internal joints... |
 |
| These didn't require shop-air drying... |
Plomb 1/2" Speed Wrench (5480) -- Before & After cleaning
After cleaning
 |
| The one on the right is the 1/2" (the one on the left is a 3/8" also Plomb and cleaned at the same time...) |
Flat files moved in the garage -- Had to move two outlets...
 |
| Moved the flat files into the garage. Just clears the circuit breaker box(!). There was a small metal cabinet on the wall that had to be removed first. Also, two outlets had to be moved up about 9 inches so that they'll still be accessible (green arrows in the above picture). |
 |
| The 240 V outlet has been moved up already. The 120 V outlets are in the process in this picture... |
Schwinn Paramount -- Installed the shift cables
 |
| Had some good condition used cables. I also have new cables but this is a used bike with used parts mostly, so using good used cables is actually more appropriate. they were already about the right length (just slightly long, which is good). |
 |
| There's built in cables guides at the bottom of the frame where the bottom bracket goes. |
 |
| The cables goes through this cable housing stop on the chain stay on the drive side. |
 |
| Then, it makes the loop through the cable housing into the rear derailleur. |
 |
| Just temporarily held the cable in place. Will cut and cap the end of the cable, after the derailleurs are adjusted. |
Subscribe to:
Posts (Atom)