I had fixed a dripping issue a few months ago.
This time, the hot water side appears to be dripping.
First, I took off the lever (just a screw holding it in place).
The large cap nut is 1 & 1/4". I happen to have the right size wrench.
It's easy to remove with the right size wrench...
Found white plastic debris in the valve's sealing area.
Also, there's some debris inside the valve (the left arrow).
Used a T-pin to pull out the debris inside the valve.
Used the right size wrench to put the valve assembly back on.
Took off the cold side valve also, just to make sure that there isn't any debris in the valve.
Checked inside the valve also to make sure there isn't any white plastic debris...
No comments:
Post a Comment