 |
| Looks like this socket holder was part of a set of tools for a specific box? (box no. 5493) |
 |
| The swing away handle is a little bit bent along it's length. |
 |
| The larger end of the socket holder is pretty bent. |
 |
| The handle is a little bent on this end, as well as the end of the box wall that's closest to the end. |
After some light cleaning (didn't want to take off too much more of the red paint).
 |
| Used some steel wool to clean the Proto Tools plate. |
 |
| Using a small hammer, straightened out the bent ends of the box and the handle. Turned out pretty good. |
 |
| Had a few 3/8" sockets handy. They're not Proto but will do for now. They fill up about 1/2 the length of this pretty long socket holder. |
No comments:
Post a Comment